Official Forum

Hi,
I just got the turbo muin smart b+ and try to set it up with my Garmin 810. I really dont find the measurements given from the Misuro very accurate. cadence constantly shift +-10 rpm, same with Watt) I use my garmin cadence sensor instead and there is no problem with cadence measurement. Now I have problem with the speed. It is ridicules low, like around 0,5 km/h. I made a test ride for 45 mins. and all I got was "moving" was around 200 meters
What is wrong with the speed?

Hi

Are you sure to have put the correct circumference value? For example, if your trainer serial number is higher than 30000, you have to put a circumference value of : circumference/13.2

Please check this table and be sure to have put the proper value (third column, non elite app/devices - connection as a speed/cadence sensor):

https://drive.google.com/open?id=0By4rZ ... 2kwUC1tUzg

Regards

hi,

yes, serial number is +50000. Circumference is set to 158 mm in the Garmin.

so what now? any answer?

Sorry for the delay, as written in the regulation of the forum we cannot answer daily here (if you need a quick answer, I suggest you to contact the customer care directly).

The circumference is correct. It is necessary to investigate further.
Please contact the customer care at real@elite-it.com and the guys there will help you to find the cause of the issue

Regards

if u change to 8,8 instead u get more ok speed as if u ride a all flat stage, it almost match stravas flat courses with speed and distance

2096/8,8