Official Forum

Hi!

The important question: How many seconds can I expect it to take, to complete a calibration on my Nero?

The reason I am asking, is that my calibrated Garmin Vector 3 pedals shows 490W at 40 Km/h and I am not that good to maintain that level of power for more than say 2-3 minutes.

I have prepared the trainer for the following conditions.
- The trainer is cold, not used for 24 hours.
- I have started the calibration immediately.
- I have went for the speed immediately, near 40 Km/h.
- I have the latest version of the firmware from Upgrado app.

Best regards
Melker

Hi

You've followed the correct steps for calibration. The only aspect that remains unclear is whether you kept the trainer folded during the entire 24-hour period. This detail is crucial for achieving accurate calibration. Therefore, kindly repeat the procedure with this consideration in mind.

If the problem persists, contact the support:
https://support.elite-it.com/en/ticket

Thanks for the reply:)
The trainer (Nero) is now folded. I will unfold it just before the calibration.
How many seconds can I expect the calibration to take, before it´s complete?
Is it like 5 seconds or is it up to 1 minute?

Best regards
Melker

It's around 5-7 seconds

Regards

Hello!

I can confirm that the calibration of my Nero went very well after performing the below steps.
I tried it twice and I received the same calibration value both times.
The calibration took like 4-5 seconds after I achieved the speed of around 40 km/h.

Best regards
Melker