Time to calibrate Nero

[reklemdnuleke]

Hi!

The important question: How many seconds can I expect it to take, to complete a calibration on my Nero?

The reason I am asking, is that my calibrated Garmin Vector 3 pedals shows 490W at 40 Km/h and I am not that good to maintain that level of power for more than say 2-3 minutes.

I have prepared the trainer for the following conditions.
- The trainer is cold, not used for 24 hours.
- I have started the calibration immediately.
- I have went for the speed immediately, near 40 Km/h.
- I have the latest version of the firmware from Upgrado app.

Best regards
Melker

[Elite Admin S]

Hi

You've followed the correct steps for calibration. The only aspect that remains unclear is whether you kept the trainer folded during the entire 24-hour period. This detail is crucial for achieving accurate calibration. Therefore, kindly repeat the procedure with this consideration in mind.

If the problem persists, contact the support:
https://support.elite-it.com/en/ticket

[reklemdnuleke]

Thanks for the reply:)
The trainer (Nero) is now folded. I will unfold it just before the calibration.
How many seconds can I expect the calibration to take, before it´s complete?
Is it like 5 seconds or is it up to 1 minute?

Best regards
Melker

[Elite Admin S]

It's around 5-7 seconds

Regards

[reklemdnuleke]

Hello!

I can confirm that the calibration of my Nero went very well after performing the below steps.
I tried it twice and I received the same calibration value both times.
The calibration took like 4-5 seconds after I achieved the speed of around 40 km/h.

Best regards
Melker